Precor UBK 885 Upright Bike

Covers are attached with minimal hardware and can be removed without taking off the pedals or cranks.

A two-step powder-coating process applies a rust-resistant undercoat and a cosmetic topcoat to the steel frame.

The bottom bracket assembly uses a hardened steel shaft with deep-groove sealed precision ball bearings designed for smooth operation and exceptional service life.

Ergonomic saddle design with comfort groove. 10.5 inches (27 cm) width quickly tapers to a narrow nose for improved riding comfort. The optional universal seat post allows easy installation of different saddle types.

A new over-molded handlebar design offers the user three comfortable riding positions: upright, cruising, and road. In the road position, the ergonomic-shaped handlebars position the wrists in a natural, neutral position. The wide handlebars provide stability and comfort across the entire forearm. The overall width of the handlebars is similar to that of indoor cycling bikes, which is narrower than most stationary bikes. This places the user in a better ergonomic position with the forearms more directly under the shoulders. In the cruising position, the wide handlebars are more comfortable on the user’s hands. Touch heart rate is integrated in the upright and road-race positions.

For double the convenience, dual-sided pedals let the rider use them with or without the integrated pedal strap. The extra-wide pedal comfortably accommodates feet of all sizes, allowing proper pedaling form with the foot directly over the user’s knee.

To achieve proper pedaling biomechanics, the seatpost and seatpost offset from the crank are key to aiding efficient pedaling and reducing shear force on the knee. The seatpost angle is 74 degrees, with a 5-inch (13 cm) offset from the crank axle. This places the forward knee directly over the ball of the foot (or the pedal spindle) when the pedals are horizontal.

3-piece crank tightens positively, reducing the need for periodic adjustments. The 170 mm crank arm accepts any standard road or mountain bike pedal.

The two-stage drive system yields a smooth, comfortable, quiet operation with a lower start-up resistance and more consistent resistance progression than single-stage drive systems.

3-phase generator/eddy-current resistance system requires no backup battery to power the bike efficiently.

Belt drive for smoother, quieter operation and reduced maintenance.

18 Readouts
Resistance Level

Total Distance, Distance Remaining
Total Calories Burned, Calories/Min, Calories/Hr, Mets, Watts
Time Elapsed, Time Remaining, Time in Zone, Segment Time
RPM, Speed, Average Speed
Heart Rate, Average Heart Rate, Max Heart Rate

17 Programs
Lose Weight
4-3 Interval
Aerobic
Fat Burner
Heart Rate Zone
Be Fit
Manual
1-1 Interval
2-1 Interval
4-1 Interval
Rolling Hills
Mountain Peaks
Hill Climb
Heart Rate Zone
Push Performance
1-4 Interval
1-2 Interval
5 K
Heart Rate Zone
Watts Target

Yes. Touch heart rate sensors are conveniently located on the handlebars in both the upright and road positions.

Yes. Integrated telemetry reads heart rate from a user’s chest strap.

The heart rate features are intended for reference only. They may not be accurate for every user or at every speed and are not intended for use as a medical device. Holding the heart rate handle touch sensor while exercising at higher intensity may also reduce the accuracy of heart rate readings and is not recommended. 

Ability to set club parameters, e.g., limit exercise time, set default language, and pause time.

Applicable country-specific power cord